3in. Scale Simplicity Road Roller

 

by Richard Folwell

 


 

 

 

Richard's Simplicity road roller first appeared in public at NSME Bits and Pieces Night in April 2019, where Richard was awarded the Bassett-Lowke Bowl, and later presented with a trophy to keep. Progress since with the roller is recorded here and updated as it happens.


 

 

 

 

 

Go to Latest Update


 

 

 

 

Two pictures of the reversing arm for the 3" scale Simplicity road roller. You may find it interesting that it is machined from solid, a piece of 2" diameter steel, rather than fabricated, which is the more usual method of manufacture - judging from models seen. Richard is currently erecting the hornplates.

 


 

 

 

 

February 7, 2020.

The pictures include the erection of the hornplate for the roller and trial fitting of brake gear, stub axle assemblies and differential/final drive shaft and bearings. Next stage is machining the boiler mounting plates.

 


 

 

 

 

February 11, 2020.

One photo shows the boiler mounting plates being machined to a nice snug fit between the hornplates. The other shows the boiler with machining completed and the firehole and damper door assembly fitted. This design has a marine type firebox very similar to the Sweet Pea railway locomotive, hence the unusual looking arrangement. The next step is to fit the smokebox, then mount the boiler at 27 degrees to the horizontal. Richard comments - "For a design the original manufacturers entitled 'Simplicity,' construction of the model is proving to be anything but!"

 


 

 

 

 

February 16, 2020.

There was a need to make some adjustable stands to align the horn/boiler/smokebox components. Using 12mm setscrews, a built up method of construction, rather than machining from 2inch bar, has been used to cut down on the amount of swarf produced. A few drops of retainer and job done. It's just possible to see one of these stands holding the hornplates level. If anyone has a 3inch scale Ben Hur action figure they no longer play with, Richard would love to have it?

 

 


 

 

 

 

February 23, 2020.

Smokebox now fully bolted to boiler - Jacked, packed and tacked ready for completion of hornplate to boiler bolts. Fingers crossed it doesn't move!

 

 


 

 

 

 

March 1, 2020

Boiler mounting completed, I'm happy to report that four years after starting this project the roller now actually rolls! The target angle of the boiler is 27, but as the photo shows it has ended up at 27.1. I contemplated 'falling on my sword' at such a dismal failure on my part, but have taken comfort in the fact that very little in life is ever perfect. So, rather than consigning the roller to a skip, I have decided to struggle on. Incidentally, I cannot praise these digital angle gauges highly enough. I've had this one for many years and used it both professionally and at home. Without it setting up the boiler would have been quite difficult.


 

 

 

March 8, 2020

 

 

 

This week I decided to erect the steering gear. It's quite a novel way of steering, using as it does a worm and gear quadrant, as opposed to a drum winding a chain as most other road steam manufacturers employed.

You can see it's very straightforward in principle, but unfortunately there does seem to be a tight spot in operation. I have two choices, either use feeler gauges to determine any error and apply all the manual skills of a neuro-surgeon to shim out any imperfection, or failing that, employ the services of a 2lb hammer. I suspect that in actual fact the steering shaft, despite being made from 1/4 inch dia stainless, is flexing. This can be rectified by a support bracket mounted on the side guard once that is made and fitted.

Please note that I did not cut the worm or gear teeth as they came with all the other cut gears, thankfully!!!!

Back to Top